PocketWizard N90M3 Motor Cord, Nikon 10 Pin to Mini – 3′ Pocket Wizard

This cable connects your radio to your camera’s remote shutter release terminal to enable remote camera triggering. This standard cable works with most PocketWizard radios but has no half-press control, and is for basic remote triggering only.

A N90M3–P (PreTrigger) cable works with most PocketWizard radios. This pre-trigger cable has a switch that allows you to toggle half-press on or off at the camera position, but not remotely. A N10-ACC or N10-ACC-200 cable allows a compatible PocketWizard radio to independently control both half-press and full-press functions, as well as relay E-TTL signals to compatible flashes when using FlexTT5s.

Standard Remote Cable for connecting a Plus II or MultiMAX with no ACC port to a Nikon 10-pin remote terminal.

Cable length: 3′ (91.5 cm)

From: 1/8″ (3.5 mm) mono miniphone
To: Nikon 10-pin remote shutter release terminal

Compatible with the following radios:

• Plus II: Use this cable to remotely fire your camera.
• Plus III: This cable can remotely fire your camera but it has no half-press control. Use aN10–ACC or N10-ACC-D200 cable for best results.
• FlexTT5: This cable can be used to remotely fire your camera, like a N90M3–P cable with a FlexTT5, but your remote camera will not be able to relay an E-TTL signal to Speedlites. Use a N10–ACC or N10-ACC-D200 cable for best results. Learn more here.
• MultiMAX with no –ACC port: Use this cable to remotely fire your camera.
• MultiMAX with –ACC port: This cable can remotely fire your camera but it has no half-press control. Use a N10–ACC or N10-ACC-D200 cable for best results.

Please see this PocketWizard Wikifor more details.

Compatible with cameras using Nikon’s 10-pin remote shutter release terminal.